ECKLUND-HARRISON TECHNOLOGIES, INC.
11000/38 Metro Parkway -- Fort Myers, FL 33912 -- USA
Telephone (941) 936-6032 | FAX (941) 936-6327

Tools and Accessories

• The EC-11 COMBINATION CAN PUNCH and COUNTERSINK and the C-12 LEVER TYPE CAN PUNCH: punch a hole and provide a flattened surface to permit installation of the C-5 and C-9 thermocouple receptacles. The C-11 is a two (2) piece "draw through" construction that requires a pilot hole to be made with an AWL. In addition to being cost-effective, it can be used on the can end as well as the can side.
• The C-12 LEVER TYPE CAN PUNCH: can be used only on the side of a can or to punch a hole in a can lid before sealing the lid to a can. It does not require a pilot hole. If you anticipate numberous tests and are inserting the thermocouple in the side of the can the speed and convenience of the C-12 makes the added cost well worthwhile.
• The C-13 END WRENCH: has a 3/4" end for tightening the C-5 and C-9 THERMOCOUPLE RECEPTACLES and a 7/16" end for tightening the C-5.2 STUFFING BOX and the C-8 packing nut.
• The C-14 THERMOCOUPLE SPANNER WRENCH: was designed specifically to torque (tighten) the thermocouple in the receptacle. Proper torqueing of the thermocouple requires only the fingers of the technician -- a wrench should never be used on the spanner wrench.
• The C-15 AWL: is used to make a pilot hole fot he C-11 COMBINATION CAN PUNCH AND COUNTERSINK. The AWL shaft diameter is 1/4" (6.4 MM)

C-11 COMBINATION CAN PUNCH

C-12 LEVER TYPE CAN PUNCH

C-13 END WRENCH

C-14 SPANNER WRENCH